Partner P 33 User Manual

Operator’s ManualREADCAREFULLYigManuale d’istruzioniLEGGERE ATTENTAMENTEiManuel d’instructionsLIREATTENTIVEMENTfBedienungsanleitungSORGFÄLTIGLESENCMan

• H: The needle screw H governs fuel flow at high speed(throttle valve fully open).To set hi speed screw H: close screw H turning it clockwi-se withou

FAULT FINDING TABLEEngine will not start Engine runs badly The chainsaw runs Engine runs badly orbut does not cut well looses power when cuttingCheck

g Due to a constant product improvement programme, the factory reserves the right tomodify technical details mentioned in this manual without prior no

P/N. 248921 (06.02)000001➔ 999999A EC Declaration of ConformityThe undersigned, authorised by E.O.P.I., declares that the petrol-driven chainsaw TH33

A.B.

C.D.

E.F.G.

H.I.L.

SPECIFICATIONSUKTHIS PRODUCT MEETS THE SAFETY STANDARD REQUIREMENT OF THE EUROPEANMACHINERY DIRECTIVEDISPLACEMENT (cm3)...

GENERAL DESCRIPTION1 - BAR2 - CHAIN3 - FUEL TANK CAP4 - OIL TANK CAP5 - STOP SWITCH6 - STARTER HOUSING7 - STARTER HANDLE8 - FRONT HANDLE9 - AIR FILTER

should therefore monitor closely the condition of theirhands or fingers. If any of the symptoms appear, seekimmediate medical advice.3 Never carry the

Never use waste oil for this purpose. This results in damageto the bar, the chain and the oil pump.Refill the chain oil tank each time the saw is refu