Partner P 350-16 36cc none AV CC User Manual

Browse online or download User Manual for Power chainsaws Partner P 350-16 36cc none AV CC. Partner P 350-16 36cc none AV CC User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
INSTRUCTION MANUAL
IMPORT ANT INFORMATION: Plea se read these in st ructi on s carefully
and make sure you underst an d th em bef o re using th is unit. Retai n th ese
instr uct i ons for future refer ence.
530164597 3/2/04
350
GB
Page view 0
1 2 ... 16

Summary of Contents

Page 1 - INSTRUCTION MANUAL

INSTRUCTION MANUALIMPORT ANT INFORMATION: Plea se read these in st ructi on s carefullyand make sure you underst an d th em bef o re using th is unit.

Page 2 - IDENTIFICATION OF SYMBOLS

10S Allow the chain to cut for you. Exert onlylight downward pressure.S Release the throttle trigger as soon asthe cut is completed, allowing the en-g

Page 3 - SAFETY RULES

11S Do not cut in an area where logs, limbs,and roots are tangled. Drag the logs into aclear area before cutting by pulling out ex-posed and cleared l

Page 4 - WARNING: Avoid kickback which

12S Keep the tree between you and the chainas much as possible.S Remove larger, supporting branches withthe cutting techniques described in BUCK-ING W

Page 5 - WARNING: Your chain saw is

13Air FilterCylinder CoverScrewsCylinderCoverSPARK PLUGThe spark plug should be replaced eachyear to ensure the engine starts easier andruns better .

Page 6 - ASSEMBLY

14TROUBLE CAUSE REMEDYEngine will notstart or will runonly a fewseconds afterstarting.1. Ignition switch of f.2. Engine flooded.3. Fuel tank empty.4.

Page 7 - DISENGAGED

15TECHNICAL DATA SHEETMODEL: Partner 350ENGINECylinder volume, cm336Stroke, mm 32Idle speed, rpm 3,000Recommended max speed, unloaded, rpm 13,000Power

Page 8 - OPERATING YOUR UNIT

16The Electrolux Group is the world’ s largest producer of powered appliances for kitchen,cleaning and outdoor use. More than 55 million Electrolux Gr

Page 9 - CUTTING METHODS

2IDENTIFICATION (WHAT IS WHAT?)ChainAdjustment Too l(Bar Tool)PrimerBulbFuel M ix Fill CapStarterHousingBar Oil Fill CapChainFront Hand Guard Front Ha

Page 10 - 1/3 of the diameter

3SAFETY RULESWARNING: Always disconnectspark plug wire and place wire where it can-not contact spark plug to prevent accidentalstarting when setting u

Page 11 - 1/3 of the

4lated place; and use an approved, markedcontainer for all fuel purposes. Wipe up allfuel spills before starting saw.S Move at least 10 feet (3 meters

Page 12 - SERVICE AND ADJUSTMENTS

5Thumb on underside ofhandlebarElbow lockedS Keep a good, firm grip on the saw with bothhands when the engine is running anddon’t let go. A firm grip

Page 13 - WARNING: Disconnect the spark

6SAFETY NOTICE: Exposure to vibrationsthrough prolonged use of gasoline poweredhand tools could cause blood vessel or nervedamage in the fingers, hand

Page 14 - TROUBLE CAUSE REMEDY

7Placechainontothesprocket7. Place chain over and behind clutch, fittingthe drive links in the clutch drum sprocket.8. Fit bottom of drive links betwe

Page 15 - TECHNICAL DATA SHEET

8OPERATING YOUR UNITBEFORE STARTING ENGINEWARNING: Be sure to read the fuelinformation in the safety rules before you be-gin. If you do not understand

Page 16

95. Push the choke/fast idle lever in to theHALF CHOKE position.OFF HALFCHOKE/FAST IDLE LEVERChoke/fast idle lever(SIDE VIEW)FULL6. Pull the starter r

Comments to this Manuals

No comments