Partner P 391 14 User Manual

INSTRUCTION MANUALIMPORTANT INFORMA TION: Please read these instructions carefullyand make sure you understand them before using this unit. Retain the

10SRelease the throttle trigger as soon asthe cut is completed, allowing the en-gine to idle. If you run the saw at fullthrottle without a cutting loa

11SDo not cut in an area where logs, limbs,and roots are tangled. Drag the logs into aclear area before cutting by pulling out ex-posed and cleared lo

12SKeep a clear work area. Frequently clearbranches out of the way to avoid trippingover them.LIMBINGSAlways limb a tree after it is cut down. Onlythe

13Remove Sawdust FromGuide Bar GrooveOil HoleSBurring of guide bar rails is a normalprocess of rail wear . Remove these burrswith a flat file.SWhen ra

14TROUBLE CAUSE REMEDYEngine will notstart or will runonly a fewseconds afterstarting.1. Ignition switch off.2. Engine flooded.3. Fuel tank empty.4. S

15DECLARATION OF CONFORMITYrelating to 2000/14/ECEU Declaration of Conformity relating to 2000/14/ECWe, Poulan/Weed Eater Division, Electrolux Home Pr

16TECHNICAL DATA SHEETEngineCylinder volume, cm339Stroke, mm 32Idle speed, rpm 3,000Recommended max.speed, unloaded, rpm 13,000Power, kW 1,8Ignition s

2IDENTIFICATION (WHAT IS WHAT?)PrimerBulbFuel Mix Fill CapStarter HousingBar Oil Fill CapChainFront Hand GuardFront HandleStarter RopeON/STOP SwitchMu

3SAFETY RULESWARNING: Always disconnectspark plug wire and place wire where it can-not contact spark plug to prevent accidentalstarting when setting u

4SMix and pour fuel in an outdoor area on bareground; store fuel in a cool, dry, well venti-lated place; and use an approved, markedcontainer for all

5Thumb on underside ofhandlebarElbow lockedSKeep a good, firm grip on the saw with bothhands when the engine is running anddon’t let go. A firm grip w

6SAFETY NOTICE:Exposure to vibrationsthrough prolonged use of gasoline poweredhand tools could cause blood vessel or nervedamage in the fingers, hands

7CUTTERS MUST F ACE INDIRECTION OF ROTA TIONTip ofBarCuttersDepth GaugeDrive Links8. Place chain over and behind clutch, fittingthe drive links in the

87. Return handle of adjustment knob tooriginal position.WARNING: If the saw is operatedwith a loose chain, the chain could jump offthe guide bar and

96. Allow the engine to run for approximately5 seconds. Then, squeeze and releasethe throttle trigger to release the fast idle,allowing the engine to